Haina
Vezérlésrögzítő
Audi, VW
Benzines motorokhoz
Teljesen új, bontatlan dobozban
Garancia | 6 hónap |
Alkalmazható | VW Polo diesel, Audi 100 1991-, A6 Z15L TDI motorral |
Elemek | |
Audi 3.0 V6 benzines motorokhoz | |
Vezérműtengely szíjtárcsa kulcs | |
Vezérműszíj feszítő kulcs | |
Főtengely rögzítő | |
Vezérműtengely rögzítő | |
Vezérműtengely fogaskerék rögzítő | |
Típus | |
Audi | A4, A6 2000-2004 3.0L V6 AVK |
Motorkód | |
Audi | BBJ, ASN, ASB, AVK |
A -- 1 x Left Camshaft Locking Fixtures (C-Shaped) | |
B -- 1 x Right Camshaft Locking Fixtures (C-Shaped) | |
C -- 1 x Tensioner Wrench with Grip | |
D -- 1 x TDC Locating Locking Pin | |
E -- 1 x 3/8" Drive Camshaft Adjuster Socket | |
F -- 1 x Tensioner Locking Pin | |
Operation | |
a. Rotate the crankshaft in a clockwise direction until the camshaft lobes at number 3 and 4 cylinders are angled upwards. | |
Fit the camshaft Locking Tools B over the camshaft lobes on cylinder numbers 3 and 4. | |
Gently rock the Crankshaft until the tools can be fitted snugly and tightened in position using the integral adjuster. | |
Remove the blanking plug from the cylinder block position rear left hand side and replace with the Crankshaft Locking TDC Locating Locking Pin. | |
b. Remove the centre blanking cap and circlip from each camshaft sprocket and slightly slacken the centre bolt. | |
Using an 8mm Hex Key turn the Tensioner Pulley anti-clockwise until the holes in both Tensioner Body and Pushrod are aligned and retain in this position with the Tensioning Pin D. | |
Once the Tensioner Pulley Bolt has been slackened the Timing Belt can be removed. | |
During the installation of the new timing belt it is necessary to turn the Camshaft Sprockets using Camshaft Adjuster Socket with a torque of 10 Nm. | |
After tightening each Camshaft Sprocket Bolt the Blanking Caps can be re-fitted with the circlips to retain. |
Youtube videók
Vélemények
Erről a termékről még nem érkezett vélemény.
Írja meg véleményét!